|
|
 |
Subscribe Today!
|
Magazine
|
Carving Community
|
Testimonials
What a wonderful magazine, every issue is like Christmas!... |
|
|
Welcome to the Woodcarving Illustrated Message Board, an online wood carving forum community where you can join thousands of carvers from around the world discussing all things related to carving. To gain full access to the message board you must register for a free account.
As a registered member you will be able to:
- Browse over 90,000 posts.
- Communicate privately with other carvers from around the world.
- Post your own photos or view from 3,500 user submitted images.
- Gain access to exclusive wood carving promotions offered by Wood Carving Illustrated and Fox Chapel Publishing.
All this and much more is available to you absolutely free when you register for an account, so sign up today!
If you have any problems with the registration process or your account login, please contact the Woodcarving Illustrated Message Board's Support Team.
|
 Woodcarving Illustrated Message Board |
|
|
|
|
Drums or "Cajons"
View Smaller Image
|
|
|
Author
|
|
Thor
Senior Member
Registered: October 2002
Location: Dahlonega, Georgia
Posts: 1,871
|
|
Fri May 5, 2006 16:48
|
Rating: 10.00
|
|
Could you give us a little more information on how these are made?
I see that they are drums, but what is the drum surface made of? Is it made like a barrel? what are the plugs for? is there an internal frame?
Thanks, Thor
------------------------------
It lived in my imagination, and now it is real.
http://www.funkychickenartproject.com/white.htm
|
|
|
|
DICK "chipncut" CAIN
Dick Cain
Registered: October 2005
Location: Hibbing, MN
Posts: 287
|
|
|
Hi Thor,
I made a 20 sided cylinder with 3/4' material. In
order to get the approximate size boards for the circle, you divide the circumference by 20. To find the bevel angle of each board you divide 20 into 360, which gives you 18 degrees. The divide that by 2 & get 9 degrees. That's the angle of the cut on each edge. Then you lay out two strips of duck tape on your bench, a few inches longer than the circumference. The lay out your strips tightly & roll the into a cylinder for a dry fit. If your joints fit good, unroll & apply polyurethane glue & reassemble & clamp, making sure it is round. Then you temporarily Glue a 1 x 2" across the top,& route out a 1/8" deep rabbet on the inside of top for 1/8" plywood. Then you set your router circle jig to cut to size the 1/8" ply top. Remove temp 1 x 2 & glue on top. I used a belt sander to round the exterior making a slight taper like barrel. The round dots on the drum are just decorative. I made them with a plug cutter.
I hope this will help. The also make router bits for cutting 9 degree angles with a router table. you may be able to find some info for making cylinders on the internet.
Dick
------------------------------
"Chipn"-"N"-"Cutn"
|
|
|
|
|
|
Powered by: PhotoPost PHP vB3 Enhanced
Copyright 2005 All Enthusiast, Inc.
All times are GMT -4. The time now is 09:09 PM.
|
|
