hello

psychomikeo500 · #1 03-10-2008, 05:32 PM

I have recently refurbished a scroll saw. This is one of the old kind with a solid cast iron overarm. My question is this. should i have the blade attached with some tension from the upper spring, or should i simply raise the lower arm to the top and clamp the blade in?

brianh · #2 03-10-2008, 09:08 PM

Hi Mike your in the chainsaw area, you may do better with this question in (Wood Carving Tips and Techniques) in the forum.

dryheat · #3 03-12-2008, 11:58 AM

You might try searching the internet for information. I have a old Rockwell and I found an "Old Machines" site where I was able to download the owners manual for my saw. A real help in maintaining and operating it. If you have trouble let me know and I'll help.
Ed

Claude · #4 03-12-2008, 01:33 PM

You need to get in to the Scroll Saw forum. Fox Chapel Publishing sponsors them, also. http://www.scrollsawer.com/forum/

Claude

Lynn O. Doughty · #5 03-12-2008, 03:02 PM

I have a Sears jig saw manufactured back in the late 30's or early 40's. Mine is also cast iron. When I change blades I run the blade all the way into the upper piston then pull it down just a bit so it doesn't bang against the upper base and break the blade. I love that old saw.

Did you know that Sears still carries parts for that saw?