Burr/cutter ID please

RiverOtterRustics · #1 01-09-2012, 02:56 PM

So I have a few of these small bits/cutters 1/8 shank and I really like them, but can't remember where I got them or who makes them or what style they even are! I thought that they might be kawasaki or dremel, but can't find them online. I've tried keywords fluted,stump cutter etc. I have an even smaller one that I found used in a box of junk at a garage sale. Would really like to find a source for these guys. Here are some pics for you experts. Thanks so much.

Jon

mobjack68 · #2 01-09-2012, 06:38 PM

I bought some Russian dental burrs (No, really!! they had Russian writing on the plastic boxes!!!) some of them are a little different cut than our American counterparts. I have not been thru all the boxes yet, I will take a look and see if I have anything close. later..
If the phone doesn't ring...it's me.

RiverOtterRustics · #3 01-09-2012, 08:15 PM

Ok found what I was looking for on Ebay..Thanks so much for the help! Turns out they were Busch Brand from Germany

Dental Burrs

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
My first box cutter blade	Ron T	Woodcarving Tools, Technology & Sharpening	2	11-28-2011 11:20 PM
The right burr for the right use??	riodot	Power Carving	3	09-27-2011 06:28 PM
craftsman all in one cutter	Robert Cahill	Woodcarving Tools, Technology & Sharpening	5	06-30-2010 07:28 PM
Box Cutter Skinny Abe	kayapee	Caricature Carving	13	02-25-2010 11:13 AM
sharpining, burr on, burr off???	minowevie	Relief and Chip Carving	9	08-12-2009 09:42 PM