Hello

tgamble57 · #1 07-13-2006, 04:03 PM

I just found this site and wanted to say hello. I am new to woodcarving and really enjoy it. I have very few tools so fare but love woodcarving. Can not emagin what just how good it will be once I get the tools I need and learn what I am doing.
Also do not know very mutch about what I am doing on the computer.

Ron D · #2 07-13-2006, 04:18 PM

welcome you'll love it here and dont be shy ask all the questions you have the people here are more than willing to answer them
ron

tgamble57 · #3 07-13-2006, 04:28 PM

Thanks Ron, I'm shy, now if I could figure out how to get someone to help me get the tools I need and a workshop I would be set. Just kidding, I think I am going to like this site very mutch.

Ron D · #4 07-13-2006, 04:38 PM

if you need tools check out ricks site at www.littleshavers.com
he has a great beginners set with everything you'll need he wont do you wrong
ron

tgamble57 · #5 07-13-2006, 04:50 PM

Thank you for that infromation, I do appreciate it. I was being a smarty pants when I sent the first mesage, an ice breaker for say. I do thank you for all help you give me.

Ron D · #6 07-13-2006, 04:53 PM

i thought that but if you are looking for tools look there he'll help you with anything you need

tgamble57 · #7 07-13-2006, 05:02 PM

I will sure check him out for sure, now if I had a rich uncle that was out of the poor house I might talk him into getting them for me. Ha Ha!!! Thanh you

tgamble57 · #8 07-13-2006, 05:06 PM

What kind of woodcarving do you do ron?

Ron D · #9 07-13-2006, 05:09 PM

a little of everything really birds woodspirts,canes just about anything .how bout you

tgamble57 · #10 07-13-2006, 05:23 PM

The only thing I have done so far is 3D in the round. I have a small duck as my first project and I am stile amazed at how well it turned out. and a fox that I am very proud of. I have been ask to do a rynorserous, do you know where I might get a patteren or advice?