[martyslc]

Hi Folks! Hope all is well where ever you may be

Is it possible to see the grain under the paint if it’s been pre-sealed?

I have done some test pieces and noticed that the piece that I didn't
pre-seal is a bit fuzzy now and I don't like that so my question is :

- Can I pre-seal (so I don't get the fussies) and still get the watered down look? I used diluted white glue to pre-seal.

- If not how do I get the non pre-sealed paint job to look smooth, not fuzzy?

Thanks a bunch,
Marty


Thanks a bunch,
Marty

[Claude]

Marty:
I would suggest getting some MinWax Sanding Sealer or some water-based satin finish varnish. I use both. The MinWax darkens the basswood a little bit, while the varnish keeps it light. Both work and prevent the acrylic paint from seeping into surrounding areas to a great extent - not as good as using the woodburner as Lynn suggests, but better than putting acrylic paint on untreated wood. If you are using oil-based paints, then just use the MinWax sealer.

Claude

[AlArchie]

Try Claud's idea on the sanding sealer. but before you put paint on over it, hit it lightly with very fine sandpaper to get the surface ready for the paint. Then try regular water colors to do your painting. They are generally transparent enough to let the grain show through.

Al