Welcome to the Woodcarving Illustrated Message Board, an online wood carving forum community where you can join thousands of carvers from around the world discussing all things related to carving. To gain full access to the message board you must register for a free account.
As a registered member you will be able to:
If you have any problems with the registration process or your account login, please contact the Woodcarving Illustrated Message Board's Support Team. |
| | ||||||
![]() |
|
| | LinkBack | Thread Tools | Display Modes |
|
#1
| |||
| |||
|
In the faq section/magazine questions and answers, there are 54 threads listed. However try to open any of them and nothing comes up. I recognize some of these threads so there should be messages with them. They shouldn't have all been in the magizine question folder though. Admin, Did you maybe move them and leave the titles? or a slight hitch in the change over for you to look into ? Don
|
|
#2
| ||||
| ||||
|
That was a tough one to figure out. All the posts that appear in Magazine Questions and Answers are the Titles only but the same titles and attached posts can be found in the Recovered On a good note it looks like the new message board will allow us to recategorize the "Recovered This has always bugged me...
|
|
#3
| |||
| |||
|
thanks, having tha old post usable without trying to remember where I saw them before will be good.
|
|
#4
| ||||
| ||||
|
Slowly we started to recategorize the Recovered |
![]() |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dog ate my magazine. | MelNM | Off Topic | 10 | 03-28-2006 10:47 AM |
| I enjoy your magazine | DICK "chipncut" CAIN | Message Board FAQ, Suggestions and Feedback | 3 | 11-12-2005 09:32 AM |
| New Magazine | Butch | General Wood Carving | 5 | 03-26-2003 09:31 PM |
| new magazine | Guest | General Wood Carving | 0 | 11-26-2002 10:23 AM |
| magazine on CD-ROM | Guest | Message Board FAQ, Suggestions and Feedback | 5 | 11-18-2002 02:05 PM |