[BobD]

Hey everyone,
Just wanted to let you know we launched our new Web site today http:\www.foxchapelpublishing.com. Right now, it's just the general page, but we are going to overhaul the Carving World and separate out the Scroll Saw section (to head off any territory issues).

You can even see my 'mug' shot by clicking on the Contact Us button.

Just to let you know.

Bob

[BobD]

Never mind, I'm not up there yet...
Bob

[Hi_Ho_Sliver]

What 'territory' issues? Some of us, myself included also do some scrollsaw work, I personally like to see it here! ???

[BobD]

I'll mention that to the tech people. Maybe we can get a link from this site to the message board for the SSW message board. We did get some complaints about the scrollers having to wade through all the carvers.

If anyone else has an opinion, let me know!

Bob

[mikeg]

Put me down for liking to see it continue to be easy to go between carving and scroll sawing!

mikeg

[don]

I read both as well and how hard is it to go straight to whichever one you want to start with

[Hi_Ho_Sliver]

We had a scroller that was a pain in the ask me about it someday! but he is no longer on here...probably the one complaining...he and a couple of his cohorts are the only ones I read that were complaining! But now I will complain, the site is changed but the type is much smaller and hard for us old folks to read....errr for 'those' old folks to read!

Hi Dave, when I come to a page with small print, if I hold down the control key, and roll my scroll button the print will get bigger. Don't know if this works for all systems or not. Hope this helps. Hugh 8)

[don]

Thanks Hugh, That worked great for me.Throw away the reading glasses......Oh wait, then I won't be able to see the tip of my knife.Maybe I need to carve bigger too. What button is that?

[Hi_Ho_Sliver]

thanks Hugh, I knew there was a way to do that.....but found out earlier it wasn't this site, it was 'myway' had taken over my toolbar and even changed the size of type! there oughta be a law! :