Making copies of my carvings - Page 2

mark yundt · #11 11-18-2007, 10:44 PM

Bob,,I also do quite a bit of work in the Catholic Dioceses. I found the thread on Work in Progress it's on page 16,,done in April of this year. I don't know how to get it to appear here for you,,but if you go to the bottom of the page and keep clicking back to previous posts you can see the finished products. The original post started on page 23 under castings.

Thanks for the compliment on the crucifix. I have done quite a few,,this though was the most interesting. The largest one I have done was 16 ft tall...that was fun. And it had to stand completly on it's own in the center of the Sanctuary balanced on it's end...looked really neat as if it was actually stuck in the marble with no visible support or bolts showing.

Just Carving · #12 11-19-2007, 08:09 AM

Mark,
Here's the link--I think:
castings almost done

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Making a mallet	woodtrapper	General Wood Carving	19	01-10-2011 11:05 PM
Making Inlays	irmsrus	General Wood Carving	1	06-20-2006 09:04 PM
A new carver in the making	Colin-Partridge	General Wood Carving	14	05-19-2005 08:54 AM
Making a strop	carver6	Woodcarving Tools, Technology & Sharpening	16	11-15-2004 07:24 PM
Making the Cut	Guest	Wood Carving for Beginners	3	04-01-2002 08:52 PM