Link To Mark Gargac Jig

Iowa Carver · #1 01-18-2009, 01:57 PM

I was thinking there was an pdf on the jig that Mark uses to cut his blanks in half on the table saw or band saw. Anyone have that?
Thanks!

Corey

Mottles · #2 01-18-2009, 04:03 PM

Hi Corey,
In the WCI Handcarved Holiday Gifts issue there is one from Chris Pye
Chris Pye: Woodcarving
If you can't find it on Pye's site and you don't have this issue. Let me know. It's for the bandsaw.
Kathy

Mark N. Akers · #3 01-18-2009, 04:29 PM

Corey:
look at the special issue of WCI(you receive it when you renew),I think it in their.

Iowa Carver · #4 01-18-2009, 06:07 PM

Thanks guys, looking for it now!

Corey

fpace · #5 01-19-2009, 11:40 AM

Hey Corey...

If you use a table saw no jig is needed... just set the blade to 45 degrees, position the fence and cut. Jig is needed only for band saw.

Mottles · #6 01-19-2009, 04:34 PM

Corey, you can do the same with a bandsaw as long your table will tilt to an 45 degree angle. That is how hubby cuts my blocks to 45 degrees. He uses another block to brace the right side.
Kathy

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mark Gargac Elf Ornament	JimSawyer	General Wood Carving	15	01-09-2009 05:27 PM
Mark Gargac dvd problem	Dennis Taylor	General Wood Carving	9	03-11-2008 05:59 PM
Mark Gargac Santa DVD	BobT	Caricature Carving	7	12-10-2007 11:08 AM
Mark Gargac article	Don by the lake	Off Topic	4	02-08-2007 10:20 AM