How do I submit an article WCI?

#1 05-18-2003, 01:37 PM

I'v been power carving for eight years. I teach begining, intermediat, and advanced power carving for the Woodcraft store (store # 503) in Roswel Ga. I also started a power carving club that meets in the store, 'The Terbo Termit Power Carvers.' I would like to submit an article on one of the figures I created for a class.
Jack Dangar

Donna_T · #2 05-30-2003, 06:17 AM

Jack,
Try using the 'CONTACT US' under CARVINGWORLD.COM

Donna_T · #3 05-30-2003, 06:20 AM

Oops again--it posted before I finished. Under teh CONTACT US list at the left of this screen, you will find email addresses for the publisher and others at WCI. I'd start with one of them.

Good luck
Donna T

#4 05-30-2003, 10:26 AM

Their are two ways - You can ask them what they want and how they want it ... or; you can study past articles to get the format they want, write the article, and send it in (over the transom is the terminology used). The first is the best, but have sold several using the latter also. Don't give up, go for it and good luck.

#5 05-30-2003, 10:36 AM

P.S. - Don't expect to get rich ... it's been years, but a couple hundred was usually tops with less than a hundred more usual. About $35 a printed page. However, with photo's you can/will receive more.